You do need to remove the arm rests from both seats. There is a wire that you run under the carpet and it plugs into the wiring harness of the car or to one of the side seat. Then I cut the foam to allow the same clearance. There are spacers for the seat that need to sit on the metal when it is bolted in. I then cut 4 holes in the carpet for the new seat. The holes for the center seat are covered under a little piece of black tape. By lifting the carpet up a little bit and looking through the holes from the side seat you can see the bolt holes for the middle seat. I had to get that completely out from under the carpet to get to the metal. Where the seat goes is a piece of foam under the carpet. I then lifted the enough to look under and see what was needed. I started by pulling both seats from the second row and part of the door seal to expose the edge of the carpet. I did it about a year ago so let's see how much I remember.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |